Search found 7 matches

by jdevente
Fri Jun 08, 2018 10:01 am
Forum: UI / General Usage
Topic: license transfer tool
Replies: 1
Views: 2484

license transfer tool

Does anyone have step by step instruction on the license transfer tool?
by jdevente
Sat Oct 21, 2017 12:16 pm
Forum: Measured Features
Topic: Probe Compensation error on circles
Replies: 10
Views: 10566

Re: Probe Compensation error on circles

You have to do the head alignment from the UCC software. You will have to place your cal. sphere on the table in your normal cal. location, then load your reference tip and place it directly above the sphere. select the advanced tab in the UCC and then select commands tab. in the drop down box at th...
by jdevente
Thu Oct 05, 2017 2:57 pm
Forum: Advanced Programming
Topic: Gear over pin diameter
Replies: 7
Views: 7020

Re: Gear over pin diameter

ok I will try this out. Nikon should add construct a circle tangent to two circles in there construct a circle options!!!
by jdevente
Thu Oct 05, 2017 1:51 pm
Forum: Advanced Programming
Topic: Gear over pin diameter
Replies: 7
Views: 7020

Re: Gear over pin diameter

Sorry. I didn’t give a very good explanation of how I’ m wanting to measure. Is it possible to measure the over pin distance (M) without measuring actual pins. I know you can construct a tangent circle of a specific diameter using 2 lines in CMM Manager but the gear teeth have radii on them where th...
by jdevente
Sun Oct 01, 2017 9:26 pm
Forum: Advanced Programming
Topic: Gear over pin diameter
Replies: 7
Views: 7020

Gear over pin diameter

Does anyone have any experience measuring an over pin diameter of a gear on a CMM?
by jdevente
Thu Sep 28, 2017 8:46 am
Forum: Measured Features
Topic: Probe Compensation error on circles
Replies: 10
Views: 10566

Re: Probe Compensation error on circles

I contacted help desk and they suggested I perform a head alignment on my PH20. in doing so it cleared out the calibration for all the tips so I calibrated all the tips and the problem still existed. I called Rod at the help desk back and he helped me collect a communication log of the issue. He sai...
by jdevente
Fri Sep 22, 2017 6:53 pm
Forum: Measured Features
Topic: Probe Compensation error on circles
Replies: 10
Views: 10566

Re: Probe Compensation error on circles

I started getting the same error on all cicles. I have a helmet microstar with ph20 head. It just started today. It started doing it even on programs that I have had already been using with no problems. It doesn't do it when using ph20 cammand points just conventional hits on a circle. I called helm...