Zeiss PRO/PRO T HAM CMM- Controller failure

Post Reply
nikhil_funde90
Getting Started
Getting Started
Posts: 3
Joined: Tue May 09, 2017 12:58 am

Zeiss PRO/PRO T HAM CMM- Controller failure

Post by nikhil_funde90 » Tue May 09, 2017 1:17 am

Hello All,

I am currently working on a project of equipment revival of CMM at Tata Motors, Jamshedpur, India. I am trying to search on internet about the various reasons for a CMM controller to fail but i am unable to find it. So, i request you all to guide me regarding the same. Links to some articles and journal papers will also be much helpful.

Thanks

User avatar
CrashN8
Site Admin
Site Admin
Posts: 519
Joined: Thu Feb 09, 2017 4:07 pm

Re: Zeiss PRO/PRO T HAM CMM- Controller failure

Post by CrashN8 » Tue May 09, 2017 10:43 am

Please give description of the error or behavior regarding this failed controller.

nikhil_funde90
Getting Started
Getting Started
Posts: 3
Joined: Tue May 09, 2017 12:58 am

Re: Zeiss PRO/PRO T HAM CMM- Controller failure

Post by nikhil_funde90 » Wed May 10, 2017 2:58 am

Thanks for the reply
I don't have any information about the absurd behaviour of the controller as I am continuing this assignment from in between and there is no data or concerned person available to give the exact information.
Can you share some information or articles about various types of failures that can occur in a Horizontal Arm Machine - CMM which is approximately 10 years old and various preventive maintenance practices that must be followed.

Post Reply