Page 1 of 1

3DConnexion Support

Posted: Mon Oct 15, 2018 5:36 pm
by JoshuaEng
Does anyone know if we can get 3Dconnexion SpaceMouse Compact working with CMM-M? I would LOVE to start using a 3D mouse with CMM-M and using hotkeys.

The annoyance is - our modeling software is compatible with the SpaceMouse so when I jump between CMM-M and our modeling software I end up trying to use it out of habit.

Re: 3DConnexion Support

Posted: Wed Oct 17, 2018 11:14 am
by medupriest
The space mouse should work the same in CMM-Manager as it is just mouse key-bindings, but I have heard some dissatisfaction with the functionality. I would suggest trying it using the space mouse you already have.

Re: 3DConnexion Support

Posted: Mon Oct 22, 2018 2:10 pm
by JoshuaEng
I have tried tweaking the settings on both CMM-M and 3DConnexion to no avail. The only function I have been able to get out of the mouse is Zoom In/Out and the side hotkeys which work great! Any suggestions are appreciated! I know it will be hard to help without the product in hand so I completely understand if this goes unresolved.
CMM MANAGER FORUM SPACE MOUES.png

Re: 3DConnexion Support

Posted: Tue Jun 04, 2019 10:59 am
by ameade022008
Any Update to this? I too have a 3dconnexion mouse as well and i'm in the same situation

Re: 3DConnexion Support

Posted: Tue Jun 04, 2019 11:55 am
by CrashN8
I had one of these devices in the office several years ago and was able to get Zoom (in & out), translate, and 3D rotate all working. I think we have a device in Brighton, MI office, I will try to get my hands on it and give updated instructions if I can get it working.

Re: 3DConnexion Support

Posted: Mon Apr 27, 2020 2:23 pm
by 007tda
Any chance this got looked at again. I am programming a lot of parts and love the 3D Connection wheels, but cannot seem to map any of the wheel controls with the current drivers, just the buttons.