Large Deviation Part Inspection

Step by step CMM-Manager tutorials
Post Reply
User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1092
Joined: Wed Feb 23, 2011 7:26 pm

Large Deviation Part Inspection

Post by US_Helpdesk » Tue Aug 05, 2014 12:12 pm

I've migrated to a new user account, see my other posts here

User avatar
mhochkins1
Nikon
Nikon
Posts: 253
Joined: Tue Mar 22, 2011 12:10 pm
Location: Linden, MI

Re: Large Deviation Part Inspection

Post by mhochkins1 » Tue Aug 05, 2014 1:13 pm

Nice Video N8
Best Regards,
Mark Hochkins

User avatar
Ryan Christopher
Nikon
Nikon
Posts: 234
Joined: Mon Jun 06, 2011 3:00 pm
Location: Sumner Washington
Contact:

Re: Large Deviation Part Inspection

Post by Ryan Christopher » Tue Aug 05, 2014 1:44 pm

This brings to mind a feature I've been wanting to see for a while...a function to "translate back" to the origin from the nominal or measured value of a feature automatically. That way I wouldn't need to write down offset values then key them in 2 seconds later.
Ryan Tackes
Applications Manager, VMS Inc.
http://www.vantagemeasure.com/

User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1092
Joined: Wed Feb 23, 2011 7:26 pm

Re: Large Deviation Part Inspection

Post by US_Helpdesk » Tue Aug 05, 2014 4:05 pm

Ryan Christopher wrote:This brings to mind a feature I've been wanting to see for a while...a function to "translate back" to the origin from the nominal or measured value of a feature automatically. That way I wouldn't need to write down offset values then key them in 2 seconds later.
We're looking to do something better than that... Relative measure options for POSITION as well as height / orientation.
I've migrated to a new user account, see my other posts here

JohnK
Frequent User
Frequent User
Posts: 48
Joined: Thu Jun 27, 2013 10:28 am

Re: Large Deviation Part Inspection

Post by JohnK » Wed Aug 06, 2014 8:41 am

I was curious why you translate the deviation in the program instead of originating X,Y on the new circle and then translating the -nominal X,Y of the circle before hitting run-time alignment.

User avatar
US_Helpdesk
Moderator
Moderator
Posts: 1092
Joined: Wed Feb 23, 2011 7:26 pm

Re: Large Deviation Part Inspection

Post by US_Helpdesk » Wed Aug 06, 2014 9:26 am

I translate so I can sync CAD later in the process... If I set origin then the CAD will sync improperly.

Note: If you are not interested in Syncing CAD you could just set origin to circle and then RunTime Align Part. In this case I add extra steps to accommodate re-syncing the CAD.
I've migrated to a new user account, see my other posts here

Post Reply