Page 1 of 1

Groove with Circular Plane

Posted: Thu Jun 25, 2020 12:51 pm
by Anegres1
Good day.

How can I Measure Groove with Circular Plane

Thanks in advance for your help

Best regards

Re: Groove with Circular Plane

Posted: Thu Jun 25, 2020 1:13 pm
by CrashN8
Do you want to measure the bottom surface of a Face Groove on a Flat Circular feature? If so, you can just measure a single point at bottom and reference to top plane or you can use Circular Plane. CAD Teach Circular Plane allows you to pick plane directly or pick 2 concentric 2D circles to establish Plane boundaries. Do you have a picture or drawing or part that helps explain what you need?

Re: Groove with Circular Plane

Posted: Thu Jun 25, 2020 1:22 pm
by Anegres1
Thanks for the reply.

I need to measure a square slot with sample points to define the height to measure, it is on an irregular pattern, with a 3mm probe

Re: Groove with Circular Plane

Posted: Thu Jun 25, 2020 4:18 pm
by CrashN8
Use a bunch of Edge Point measurements then best-fit construction to create slot. During best-fit construction you can specify work-plane.

Re: Groove with Circular Plane

Posted: Fri Jun 26, 2020 11:45 am
by Anegres1
Thanks for the feedback