Page 1 of 1

RPS POSSIBLE SOLUTIONS

Posted: Wed Dec 04, 2019 7:49 am
by smudge611
Setting up a program for a Rear Combination Light fixture. During a RPS Alignment I get the Possible Solutions dialogue.
How am I supposed to know which is the correct one to choose?
If you look at the screenshot
Sphere 2 is origin
sphere 3 is rotation and
sphere 1 is align

Re: RPS POSSIBLE SOLUTIONS

Posted: Wed Dec 04, 2019 10:53 am
by Ryan Christopher
I get confused when the cad coordinate system is way out in space.

You might be happier if you move your cad coordinate system to the cad model before you start doing this alignment.

That said...from your description, I would expect this to be the solution:

X Y Z
SPHERE 1 O O X
SPHERE 2 X X X
SPHERE 3 O X X

Good luck!

Re: RPS POSSIBLE SOLUTIONS

Posted: Thu Dec 12, 2019 1:45 pm
by smudge611
How exactly do I move the coordinate system?

Re: RPS POSSIBLE SOLUTIONS

Posted: Mon Dec 16, 2019 10:25 am
by Ryan Christopher
The tools are under this dropdown button...

RIBBON > Import/Export > Alignment